Why atos command gives the same hex number entered

Asked Jun 25 '13 at 06:15

Active Jun 25 '13 at 06:15

Viewed 136 times

I have used

atos -arch armv7 -o myappname 0x6ce59f84

It gives 0x6ce59f84 as the result. I followed the instructions mentioned in https://stackoverflow.com/a/4954949

Why this display as the number i have entered.

edited May 23 '17 at 12:11

Community

asked Jun 25 '13 at 06:15

Susitha

1

Has your release binary been stripped of symbols? – paxdiablo Jun 25 '13 at 06:19
I am new for iOS dev. I dont know whether, i have enabled it or not. How can i confirm about that from a released binary. – Susitha Jun 25 '13 at 06:23
If you have to ask, then it is true. The default behavior of a release build is to remove this information so other cannot see it. – borrrden Jun 25 '13 at 06:35
These are the settings i have set. -Strip debug Symbols During Copy -Debug -NO -Release -Yes – Susitha Jun 25 '13 at 06:39

0 Answers0