Fast way to cook steel-cut oats when no microwave is available

Question

I am looking for a way to prepare fast steel-cut oats.
I do not have a microwave, and I would like to have them for breakfast but I can not cook for ~40 mins to prepare them in the morning.
I have tried to cook them by simmering them ~10 mins till the water is gone but they did not taste good (were actually uncooked).
I have also tried leaving them overnight in a bowl of milk but they were not easy to eat either (was like chewing gum)
Note1: yes I know about instant oats etc but these are less nutritious than steel-cut oats so I am looking for a way to prepare them fast.

Note2: I don't care if the fast method suggested is for a warm or cold recipe. Either warm or cold are fine by me.

This is like asking if there's a way to make rice in under 20 minutes... Do you have a rice cooker with a timer? — Catija, Oct 31 '15 at 23:10
Are you open to going the opposite direction and doing some prep the night before? Recipes for slow-cooker steel cut oats aren't too unusual... — logophobe, Oct 31 '15 at 23:49
I cook a large batch on Sunday night and then simply put servings of it in the microwave every morning. Steel cut oats are sturdy enough that they can be eaten days later and still taste pretty much the same. — Erica, Nov 01 '15 at 00:26
@logophobe:Yes I don't mind doing something the night before — Jim, Nov 01 '15 at 08:40
@Jim I know, that's what I do. They can also be eaten cold, or stirred for a couple minutes in a pot to reheat. The microwave step does not (substantially) further cook the oats. — Erica, Nov 01 '15 at 11:03
@Erica: 1) What is the ratio of water/oats for the large batch on Sunday night? 2) What is the proper temperature/water addition ration for reheat in a pot? — Jim, Nov 01 '15 at 11:55
@Jim 1) Standard (4:1) and 2) no water, temperature depends on how warm you want them. Frankly, I find them tastiest cold. — Erica, Nov 02 '15 at 16:18
related: https://cooking.stackexchange.com/questions/47097/whats-the-fastest-way-to-cook-oatmeal-porridge — rumtscho, Aug 03 '18 at 16:21

Ecnerwal · Answer 1 · 2015-11-02T13:12:23.810

2

My low-effort steel cut is to set the bowl of steel-cut and water in a steamer and let it go about 20 minutes (or longer) - unlike (my experience of) cooking them in a pot, there's no stirring, boilovers, or other drama. IME the drama fully applies in the microwave and no time is saved by it. But you are not going to cook them in 10 minutes time (2 minutes active work, yes, 10 minutes time, no.) On the other hand, I don't see why you'd be cooking for 40 minutes in any case.

Edit: I begin to suspect from the comments that @Jim is not familiar with the concept of steaming. So, steaming, the short explanation: A small amount of water in a large enough pot. A rack set on the bottom of the pot to elevate the bowl. A bowl contianing food (in this case, steel cut oats and water in a ratio of 1:2) is set on the rack above the water. The lid is put on the pot, the water is boiled, the steam in the pot cooks the food.

Other method I haven't used in years but which worked then and should work now, is to put the oats and boiling water into a wide-mouthed thermos flask the night before. Given that the main reason I haven't done it in years was that I dropped and broke the glass on my wide mouth thermos flask, I would suggest a stainless-steel version rather than a glass version (my stainless steel narrow-mouthed flask is old and dented and still going strong, more than 3 decades after it was new. But I wouldn't want to put anything other than a liquid in it due to the size of the mouth.)

edited Nov 02 '15 at 13:12

answered Nov 01 '15 at 00:26

Ecnerwal

17,550
27
65

There's actually a style of cooking in vacuum flasks ... you can find rather large ones sold as 'thermal cookers' – Joe Nov 01 '15 at 02:24
@Ecnerwal: In your answer you already mention 20 mins (or longer). I have never been able to cook it for under 30 because usually the water was not gone. – Jim Nov 01 '15 at 08:45
@Ecnerwal: The suggestion with the termos flask is interesting. Just boil the water and let it overnight and it does the job? Closed Iid I assume – Jim Nov 01 '15 at 08:47
1

@Jim what do you mean"because the water was usually not gone"? You cook oats until they're through, and if the water isn't gone by then, you can throw it out or start with less water next time. – rumtscho Nov 01 '15 at 09:22
@rumtscho:But I was under the impression that the oats are done when the water is evaporated. I use 1 cup oats 4 cups water – Jim Nov 01 '15 at 11:46
"Or longer" mostly means I don't watch the pot closely, nor set a timer, and can get caught up in other things before I recall that the oats should be done and turn them off. They are not ruined by cooking longer (in the steamer), but 20 minutes is enough time. You're using about twice as much water as needed. Lid on the thermos flask, yes. Hmm. I shall have to investigate "thermal cookers." – Ecnerwal Nov 01 '15 at 14:19
@Ecnerwal:How much water then? Do you put the pot lid?I have noticed that if I am not constantly around to stir they water gets "inflated" and can get off the pot – Jim Nov 01 '15 at 21:30
@Jim 2x water to oats. Or, half what you have been using, which goes along with the fact that I said you were using twice as much as you need to...and you seem to have missed the point about steaming .vs. boiling, which is what gets you away from stirring and boil-overs. – Ecnerwal Nov 01 '15 at 21:58
@Ecnerwal:I have an electric kitchen with heat from 0-9. I place them at 4 with lid covered – Jim Nov 02 '15 at 09:18

score 2 · Answer 2 · answered Nov 02 '15 at 01:23

2

I usually leave mine overnight. Bring the water to a boil, throw the oats in, stir, cover, and remove from heat. In the morning they just need a quick reheat.

answered Nov 02 '15 at 01:23

miken32

602
2
9
23

score 0 · Answer 3 · answered Nov 01 '15 at 09:03

0

One way to prepare oats which allows them to be stored and eaten cold and which avoids excessive chewiness is to make flapjack. I sometimes do this at the weekend to eat it as breakfast over the course of the week. In the absolute minimal form you just need butter and oats (I've tried roasting oats by themselves, but it's too easy to burn them). Without any sugar to bind them the result is very crumbly but perfectly edible. You can add sugar, fruit, etc. before baking or search for more elaborate recipes as desired. If you care about the calcium from the dairy then you can eat them with yoghurt.

answered Nov 01 '15 at 09:03

Peter Taylor

1,994
16
25

Interesting approach. But is there a way to avoid butter? E.g. non-stick pan? In what temperature do you cook them? – Jim Nov 01 '15 at 11:48
I've tried without butter once - essentially just roasting the oats in a tin - and they burnt. It might work if you're willing to babysit the oven, but I'm not planning to repeat the experiment. I cook them at 180C, but there's going to be some flexibility there. – Peter Taylor Nov 01 '15 at 18:52

score 0 · Answer 4 · answered Nov 02 '15 at 16:01

0

Try soaking the oats in cold water overnight- they will absorb some of the water, but faster, according to "The Joy of Cooking"

answered Nov 02 '15 at 16:01

michael

111
2

Fast way to cook steel-cut oats when no microwave is available

4 Answers4

Linked